Filter
Top Products
Note:
O
The camera cannot be affi xed to painted or glass surfaces which have been treated
with fl uoroplastics (treatments which shed water droplets, mud etc.), or to re-painted
surfaces.
Make connections and placement tentatively at fi rst, to check positions. Repeated
affi xing weakens the adhesive.
O
The screw holes to use, and the possible angle adjustment, vary according to the
mounting position. Adjust the angle and check that the required fi eld of view is
visible. (It is not possible to re-affi x components.)
O
Mount the camera so that it does not contact the vehicle body or rear wipers.
QFor secure mounting
O
Do not work outdoors in rainy weather.
O
When the air temperature is low, use the vehicle’s interior heater or defogger, or a
dryer, to warm the bonding area.
O
Use a dryer etc. to thoroughly remove all moisture. Dirt and moisture on the bonding
surface reduce bond strength and could cause the camera to fall off.
O
After mounting the camera, do not expose it to rain or other water, pull it or subject it
to strong forces for 24 hours.
Rear view camera
Wipe away all oil and dirt etc. from the mounting surface.
Before mounting
Mounting procedure