Filter
Top Products
EN
6
For continuous use, always connect the USB
Communications Hub to the computer using the USB
cable provided.
There is a registration mode with the main unit when
the USB Communications Hub is turned on the first
time, or after each installation. Users can also force a
registration.
To register with the main unit:
• Press and hold
SEARCH at the back of USB
Communications Hub to enter registration mode.
• Press and hold
UP + DOWN at the back of main unit
to enter registration mode.
SET UP MAIN UNIT
NOTE Set up the remote sensor and USB Communications
Hub before installing the main unit.
1. Remove the battery compartment cover.
2. Insert the batteries, matching the polarities.
3. Press RESET after each battery change.
NOTE Batteries should not be exposed to excessive
heat such as sunshine or fire.
DATA TRANSMISSION
To upload / download weather data:
• Install and start the PC software.
• Select world cities in the software programme.
• Set up the remote sensor.
• Connect the USB Communications Hub to the computer
.
• Set up the main unit and register it with the USB
Communications Hub.
IMPORTANT
• Always connect the USB Communications Hub to
the computer.
• Ensure Sleep Mode on computer is disabled as this
will adversely affect the operation.
TO DISABLE SLEEP MODE ON COMPUTER
(WINDOWS XP OR EARLIER VERSION)
1. Right click on Desktop.
2. Choose “Properties”.
3. Click on “Screen Saver” Tab in the Display Properties
window.
4. Click on “Power” located at the bottom half of window.
5. A new window “Power Options Properties” will open.