Nissan 4083 Automobile User Manual


 
6 ’98-’99 Frontier – Kit# 4083
39. Double-check the vehicle. Check all mounting
hardware to be sure that it is properly tightened. Check all
wires, hoses, cables, etc. to be sure that there is ample
slack. Check the vehicle electrical system. Start the
vehicle. Check the steering in both directions to be sure
that there is no bind. Check clutch operation. Check the
operation of the brake system and the parking brake.
Check both shift levers’ operation. Be sure that there is
proper engagement in all gears and 4 wheel drive ranges.
Check coolant level. Caution: never open a closed
cooling system after the vehicle has been started. Only fill
the cooling system if the cap has been removed while the
vehicle was still cold. Fill the coolant to the proper level.
Reinstall the radiator cap. Carefully check all hoses to be
certain that they have been connected properly and that
there is ample slack. With the amount of hoses on this
vehicle, it is vital that this be checked thoroughly. Test-
drive the vehicle in all gears and 4 wheel drive ranges.
Pay very close attention to all vehicle systems. Check all
hardware again in 500 miles and as part of your regular
maintenance schedule.
CAUTION
Performance Accessories does not recommend any
particular wheel and tire combinations for use with its
body lifts and can not assume responsibility for the
customer’s choice of wheels and tires. Your owner's
manual can be referenced for recommended tire sizes
and warnings related to the use of oversized tires. Larger
wheel and tire combinations increase stress and wear on
steering and suspension components, which leads to
increased maintenance and higher risk for component
failure. Larger wheel and tire combinations also alter
speedometer calibration, braking effectiveness, center of
gravity, and handling characteristics. Consult with an
experienced local off road shop to find what wheel and tire
combinations work best with your vehicle.
NOTE
All warranty information, instruction sheets, and other
documents regarding the installation of this product
must be retained by the vehicle owner. Information
contained in the instructions and on the warranty card
will be required for any warranty claims. The vehicle
owner needs to understand the modifications that have
been made to his vehicle and how they affect the
handling and performance of the vehicle. Failure to
provide the customer with this information can result in
damage to the vehicle and possible personal injury.
Kit Parts List.
Quantity Description
6 3” x 3” blocks
6 3” x 2” blocks
1 3” Lower Radiator Support
1 Bracket, Front - Right
1 Bracket, Front - Left
2 Outer Cab Support Plates
1 Bracket, Power Steering Reservoir
1 Bracket, Parking Brake
2 Spacers, Bed W/ Holes
4 Spacers, Bed W/O Holes
1 Extension, Fuel Filler
1 Extension, Shift
1 Hose, Rubber ½” - 19”
1 Hose, Rubber ¼” - 17”
1 Instruction Sheet
1 Loctite
1 Logo Label
1 Warning Label
Bolt Pack
2 Bolt, M10-1.25 x 180 (Fine Thread)
4 Bolt, 7/16-14 x 7”
2 Bolt, ½-13 x 4-1/2”
2 Bolt, ½-13 x 5”
2 Bolt, ½-13 x 5-1/2”
6 Nut, Nylock ½-13
6 Washer, ½ USS
6 Washer, ½” Thick
4 Nut, Nylock 7/16-14
6 Washer, 3/8” USS
1 Bolt, 3/8-24 x 1-1/4”
1 Steering Extension
Hardware Pack
2 Bolt, M10-1.25 x 100 (Fine Thread)
5 Bolt, ¼-20 x 1”
5 Nut, Nylock ¼”
10 Washer, ¼” SAE
4 Bolt, 5/16-18 x 1”
4 Nut, Nylock 5/16-18
8 Washers, 5/16 USS
2 Bolt, 3/8-16 x 1”
2 Nut, Nylock 3/8-16
4 Washer, 3/8 USS
16 Bolt, 7/16-14 x 1”
16 Nut, Nylock 7/16-14
24 Washer, 7/16 USS
8 Washer, 7/16 SAE
4 Clamp, Hose #6
4 Clamp, Hose #10
2 Clamp, Hose #28
2 Pin, Roll 1/8” x 1”
1 Extension, 3” Shift Pin
1 Hose, Vacuum Extension Tube
1 Hose, Heater Extension Tube
2 Hose, Extension, Fan Shroud/Heater
Rev 03, Copyright 04/06
Performance Automotive Group