Filter
Top Products
06
FAN SPEED CONTROL DIAL
Turn the fan speed control dial
to the left (slow) or right (fast) to control fan
speed.
TEMPERATURE CONTROL DIAL
Turn the temperature control dial for the desired temperature. Turn the control dial
to the left for cold air or right for hot air.
AIR FLOW CONTROL DIAL
Turn the dial to select the following air flow outlets:
Air flows from the center and side vents.
Air flows from the center, side, and foot vents.
Air flows mainly from the foot vents.
Air flows from the defroster and foot vents.
Air flows mainly from the defroster vents.
DEFROSTING/DEFOGGING FRONT AND SIDE WINDOWS
Turn the air flow control dial to the front window defroster mode
. The A/C
automatically turns on when the defroster mode is selected.
Turn the temperature control dial left or right to set the desired temperature.
To set the defroster on high, turn the fan speed dial all the way to the right.
REAR WINDOW DEFROSTER
Push the rear window defroster switch on. Push the switch again to manually
turn the defroster off. This function automatically turns off in approximately 15
minutes.
A/C ON/OFF BUTTON (if so equipped)
Press the A/C button to turn the A/C on or off.
AIR RECIRCULATION BUTTON
Press the air recirculation button to recirculate air inside the vehicle.
Press the air recirculation button again to turn air recirculation off.
The air recirculation mode cannot be selected if the air flow control dial is in the
defrost position
.
05
04
03
02
01
MANUAL CLIMATE CONTROL (if so equipped)
05
01
02
03
07
05
07
06
RADIO BUTTON
Pressing the RADIO button will change the band to either FM, AM or SAT* radio stations.
When the radio select button is pressed while the ignition switch is in ACC or ON, the
radio will come on at the station last played.
SCAN BUTTON
Press the SCAN button. When listening to the radio it will stop at each station that has
significant signal strength for 5 seconds. If listening to a CD, it will select the previous/
next selections.
AUDIO
BUTTON
Press the AUDIO button until the desired mode appears in the display, then use the
<
or
<
buttons to adjust the tone quality and speaker balance (for example, Bass, Treble, Fader,
Balance) to the desired level.
RADIO MANUAL TUNING BUTTON/CLOCk BUTTONS/SEEk
Press
<
or
<
for less than 0.5 seconds to manually change radio stations. Press for more
than 0.5 seconds to find the next broadcasting station with a strong signal.
STATION AND CD SELECT BUTTONS
To store a station in a preset you must first select A, B, or C memory bank by pressing the
PRESET A·B·C button and tune to the desired AM, FM or SAT* station. Then press the
desired station select button for at least 2 seconds. When the preset indicator illuminates,
a beep will sound, indicating memorization is complete. To retrieve a previously set station,
select the memory bank where the preset was set, then press the corresponding station
select button.
CD-C/AUX BUTTON
Activates and displays CD play functions and audio for devices plugged into the
AUX IN jack.
PRESET A·B·C BUTTON
Press the PRESET A·B·C button until you reach the desired setting. The radio is
equipped with three separate banks, each with six station presets. You may store any
combination of AM, FM, or SAT* radio presets on each bank.
RPT BUTTON
Press to change the play pattern as follows: 1 – The current selection is repeated.
NORMAL (no symbol will appear) – All selections are played in sequence.
MIX (RANDOM PLAy) BUTTON
Selections are played at random, not following the sequence on the compact disc. The
same program may be repeated twice.
CAT BUTTON (if so equipped)
Category button for satellite radio (if activated).
AUX IN
Plug in and play a compatible device, such as an MP3 player.
01
05
04
03
02
01
06
02
04
03
05
07 08 100906
07
08
09
10
FM/AM/SAT* RADIO WITH COMPACT DISC (CD) CHANGER (if so equipped)
* SAT presets are only available on SAT equipped vehicles.
01
04
WINDSHIELD WIPER/WASHER SWITCH
The ignition switch must be in the ON
position to activate the windshield
wipers.
Push the lever down to operate the
windshield wipers.
Switch operation includes:
LCN0044
Intermittent (if so equipped) – Wipers
operate intermittently and can be
adjusted by turning the time control.
LCN0045
Low speed – Wipers operate at a continuous low speed.
LCN0046
High speed – Wipers operate at a continuous high speed.
LCN0042
Wash – Pull the lever toward you. Wipers automatically wipe several times.
03
HEADLIGHT AND TURN SIGNAL CONTROL
HEADLIGHT SWITCH
Turn the headlight switch to the
position to turn on the front parking, tail,
license plate and instrument panel lights.
Turn the headlight switch to the
position to turn on the headlights. All other
lights remain on.
HIGH BEAM
Push the headlight switch forward to select the high beam function. The blue
indicator light illuminates. Pull the headlight switch back to the original position to
select the low beam. The blue indicator light goes off.
Pull and release the headlight switch to flash the headlight high beams on and off.
TURN SIGNAL SWITCH
Move the headlight control switch up or down to signal the turning direction.
When the turn is completed, the turn signals cancel automatically.
To signal a lane change, move the headlight control switch up or down to the
point where the indicator light begins to flash, but the headlight control switch
does not latch.
FOG LIGHT OPERATION (if so equipped)
Note: The headlights must be on and the low beams selected for the fog lights to
operate.
Turn the switch to the position to turn on the fog lights.
Turn the switch to the OFF position to turn off the fog lights.
CRUISE CONTROL (if so equipped)
To activate the cruise control, push the
(ON/OFF) switch on. The indicator light
in the instrument panel comes on.
To set cruising speed, accelerate the
vehicle to desired speed, push the
COAST/SET switch and release it. The
SET indicator light in the instrument
panel will illuminate.
To reset at a faster cruising speed, push and hold the ACCEL/RES switch.
When the vehicle attains the speed you desire, release the switch.
To reset at a slower cruising speed, push and hold the COAST/SET switch.
Release the switch when the vehicle slows to the desired speed.
To resume a preset speed, push and release the ACCEL/RES switch. The
vehicle returns to the last set cruising speed when the vehicle speed is over 30
MPH (48 km/h).
To cancel cruise control, push the CANCEL switch. The SET indicator light in
the instrument panel will go out.
To turn off cruise control, push the (ON/OFF) switch. Both the CRUISE
indicator light and the SET light in the instrument panel will go out.
02
04
TRIP COMPUTER (if so equipped)
The trip computer readout is in the speedometer
display. It can show the following items:
TRIP “A” – Measures the distance of one
specific trip.
TRIP “B” – Measures the distance of a
second specific trip.
OUTSIDE AIR TEMPERATURE – The
temperature is displayed in °F or °C. The
word “ICY” will display if temperatures are below 37°F (3°C).
DISTANCE TO EMPTY (dte) – Estimates the distance that can be driven
before refueling.
AVERAGE FUEL CONSUMPTION – (mpg or l/100km) Shows the average fuel
consumption since the last reset.
AVERAGE SPEED – (mph or km/h) Shows the average speed since the last reset.
JOURNEY TIME – Shows the time since the last reset.
RESET – Press the CHANGE button on the instrument panel for more than
1 second to reset the trip odometer to zero.
With the ignition key in the ON position or the vehicle running, you can select an
item by pressing the CHANGE button on the instrument panel.
HEADLIGHT AND TURN SIGNAL
CONTROL (BEHIND STEERING WHEEL)
AUDIO SySTEM
OUTSIDE MIRROR CONTROL SWITCH
(BEHIND STEERING WHEEL)
03
01
CLIMATE CONTROLS
02
TRIP COMPUTER
CRUISE CONTROL
WINDSHIELD WIPER/
WASHER SWITCH
05
06
04
TRUNk LID OPENER
11
11
04
06