Filter
Top Products
3
Installation
GP-N100 Utility Software Manual
Installing the Device Driver (Windows XP Only)
Installing the Device Driver (Windows XP Only)
After installing the GP-N100 Utility under Windows XP, you will need to install the two GP-N100
device drivers.
1
After making sure that the computer is on and
that Windows is running, connect the GP-N100
via USB. The “Found New Hardware Wizard” will
start; if the dialog shown at right is displayed,
select No, not this time and click Next. If this
dialog is not displayed, proceed to Step 2.
2
Select Install the software automatically
(Recommended) and click
Next
to start in-
stallation. If a warning is displayed during the
install, click
Continue
.
3
Click Finish to exit the installer when installation is complete. Installation for the second driver
will then begin as described in Step 1; follow the steps above to install the second driver.