Filter
Top Products
Blue Sky Network August 07
10 D3000 100458
D3000 Terminal + ICB Integration
1- Decide where in the vehicle or vessel (dashboard, ceiling etc) the D3000 will be installed. For
instance, if the unit is going to be installed in the ceiling, the installer will need to fix the D3000
ICB set upside down in relation to the standard dashboard mount (see below). Start by affixing
the bracket (ICB) in the desired position using a suction mount, velcro tape or screws;
Dashboard Mount-style
Ceiling Mount-style
2- Align the bracket and terminal directions as shown below (cables always to the back side).
Mount the round rubber mount on the right and left sides of the D3000 in a manner that allows
the side screws to fit the top hole (out of the three, the one closest to edge) on the sides of the
bracket (see below).
a) Position the bracket
b) Align the terminal’s back with ICB cables
Rubber
Mount
Side
Screw
c) Insert side screws
Attach the screws from the outside of each side of the bracket so that it goes through the bracket
hole and screws into the rubber mount, which is attached to the D3000 Terminal. Screw it in
firmly, but do not over-tighten.