B10 Bluetooth GPS Receiver | How do I get started?
14
By USB cable
To charge the battery via the USB cable:
Plug the large end of the USB cable directly into a USB port on your computer (not a USB
hub); plug the small end into the side of the B10 receiver. The battery status light on the front
of your B10 receiver turns on.
Where possible, plug the USB cable into a USB port at the back of your computer.
When the battery is charging, the battery status light is green. When the battery is fully charged, the
light is off. If you don’t see the status light even momentarily, try another USB port on your computer.
Rechargeable batteries have a limited number of charge cycles. Battery life and number of charge cycles vary by use
and settings.