Filter
Top Products
REPEAT 3100 Installation and Operation Manual
NAVMAN
6
+
+
Hold
+
Hold
+
5 sec
Increase value
or change
NMEA item
Decrease value
or change
NMEA item
Turn Simulate
on or off
Reset to factory
defaults
Adjust backlight
(4 levels or off)
Change display mode, between
Dual mode, Wind mode and
NMEA mode
Select NMEA
data to display
+
+
+
+
Return to
normal
operation
2-6 Key reference
Setup
Turn power on
Normal operation
Set Backlight
Group
NMEA Mode displays one item of data at a time from
any compatible NMEA instrument. To select which
NMEA data can be displayed, see section 5-2,
step 2. To change the item displayed, press or
one or more times.
2-4 Changing units
To change the units on the REPEAT 3100, change
the units on the instrument which sends the data to
the REPEAT 3100.
Change item of data displayed
+
Set UTC offset
(for time display)
Turn NMEA
function display
ON or OFF
+
+
+
Change item of data displayed
2-5 Simulate
Simulate allows you to become familiar with the
REPEAT 3100 off the water. When simulate is on,
the unit functions normally except that the data from
other instruments is ignored and the unit generates
this data internally. The word SIM flashes at the
bottom, right corner of the screen if:
The REPEAT 3100 has simulate on.
Any instrument connected to the REPEAT
3100 by the NavBus has simulate on.
To turn simulate on or off in the REPEAT 3100:
1 Turn the power off.
2 Hold down
+
while you turn the power on.