Filter
Top Products
PAGE 8 — WBH16/WBH16E POWER BUGGY (S/N 110401 & UP) • OPERATION AND PARTSMANUAL — REV. #0 (06/14/11)
SAFETY INFORMATION
DO NOT operate the power buggy at excessive speeds.
Reckless operation may cause accidents and severe
injury. Slow down when approaching people, wet areas,
and going up and down grades. It is the responsibility of
the operator to adjust speed, as necessary, depending
on the conditions of the road or path.
ALLOW extra time to stop when operating the power
buggy ion wet surfaces or loosely graded materials.
ONLY remove the outer tires when it is necessary to
reduce the width of the power buggy in order to access
narrow work areas. If outer tires are removed, the power
buggy must only be used on level, solid surfaces such
as concrete, asphalt, or compacted stone to prevent the
power buggy from tipping. The maximum load must also
be reduced to 1000 lb.
DO NOT dump materials that are large and chunky.
These types of material may shift causing the power
buggy to tip and throw the operator off the machine. The
power buggy is intended for dumping free-fl owing and
loose materials such as dry soil, slag, and wet concrete.
DO NOT dump materials from bucket while the power
buggy is moving.
For walk behind operation, the operator platform must be
stowed and locked in the up position. The speed should
also be reduced to 3 mph or slower.
NOTICE
ALWAYS ensure power buggy is securely placed on
appropriate blocks or jackstands when performing
maintenance requires elevation of the buggy.
ALWAYS make sure the power buggy’s brakes are
working properly. Check brake linkage and adjust as
required. NEVER operate the power buggy with a
defective braking system.
Ensure brakes are applied when leaving or when using
on a slope.
When parking on a slope, position the power buggy at
a right angle to a slope. Ensure that the parking brake
is engaged and holds the power buggy safely in place
when parking on a slope.
ALWAYS block the power buggy with appropriate blocks
when leaving the power buggy parked on a slope.
To prevent unexpected loss of control, DO NOT
start
engine on a sloping surface.
Ensure that the speed control lever works freely and
returns to the closed position. DO NOT start engine
unless speed control linkage is working properly.
Make sure that the tires are infl ated to the manufacturer’s
recommended tire pressure.
NEVER
operate the power buggy with bad or worn tires.
ALWAYS replace defective tires with new ones.
ALWAYS
make sure the hydraulic dumping mechanism
of the tub is working properly.
Avoid sudden stops and starts and changes in direction.
Operate the controls smoothly. DO NOT
jerk the steering
or any other controls.
NEVER attempt to work the control except from the
operator’s position.
NEVER drive or tow the power buggy in traffi c or on
public roads.
ALWAYS
keep the machine in proper running condition.
Fix damage to machine and replace any broken parts
immediately.
The entire power buggy (tub, step plate, shroud, wheels,
etc.) should be cleaned after every use. Make sure there
is no buildup of concrete, grease, oil or debris on the
machine.
ALWAYS
store equipment properly when it is not being
used. Equipment should be stored in a clean, dry location
out of the reach of children and unauthorized personnel.