Filter
Top Products
PAGE 10 — PS4030 MULTIQUIP SAW • PARTS MANUAL — REV. #1 (11/03/09)
TO ADJUST DEPTH LOOSEN POINTER KNOB, ROTATE POINTER TO
DESIRED DEPTH AND RETIGHTEN POINTER KNOB TO LOCK IN CUTTING DEPTH.
FORWARD
NEUTRAL
REVERSE
OPERATING INSTRUCTIONS
BEFORE
STARTING:
WATER
SUPPLY:
BLADES:
STARTING
ENGINE:
Check all fluid levels. Secure blade firmly to
bladeshaft. Make sure all protective guards
are in place and properly mounted. Wear eye,
ear protection and protective clothing.
Connect water supply to water inlet. Move
water ON/OFF CONTROL to ON position.
Adjust WATER FLOW CONTROL lever to
desired position. Drain watering system in
cold weather to prevent freezing damage.
Always follow blade manufacturer's
recommendations for blade selection,
speed and application.
WARNING!
NEVER exceed blade manufacturer's
maximum rated RPM. See operator's manual
for detailed blade mounting instructions.
Set CONTROL HANDLE to NEUTRAL position.
Set THROTTLE to IDLE. Turn start switch to
ON position. Wait for glow plug indicator light
to go out. Momentarily turn switch to start
position; release switch as soon as engine
starts. Allow engine to warm up for several
minutes before increasing engine speed. Use
approved diesel fuel only.
RAISE/LOWER
CONTROL
OFF
TO ADJUST CUT DEPTH INDICATOR
LOWER SAW UNTIL BLADE CONTACTS
SURFACE, ADJUST DIAL TO ZERO.
WATER PUMP
ON
0
0
Inch
mm
DEPTH INDICATOR
DEPTH STOP
STOPPING
ENGINE:
Do not stop engine abruptly when hot! Reduce
THROTTLE to IDLE and allow engine to run 1
to 2 minutes before turning ignition switch off.
Damage to engine may occur if not allowed to
cool adequately.
LOWER
RAISE
20
40
60
80
100
120
140
160
180
200
220
240
260
280
300
1
2
3
4
5
6
7
8
9
10
11
12
ENGINE WILL
NOT CRANK
WHEN E-STOP
BUTTON IS
DEPRESSED
BLADE SPEED
TACHOMETER
37731
REV
04
ENGINE PRE-HEAT
GLOW PLUG
OFF
ON
ENGINE
PRE-HEAT
START
SYSTEMS STATUS
IGNITION SWITCH
BLADESHAFT
DIS-ENGAGE
ENGAGE
LIGHTS
ON
OFF
THROTTLE
AUXILIARY
ON
OFF
TO INCREASE ENGINE SPEED: TURN KNOB COUNTERCLOCKWISE .
TO REDUCE ENGINE SPEED: TURN KNOB CLOCKWISE.
FOR QUICK THROTTLE ACTION: DEPRESSRED BUTTON AND
PUSH OR PULL KNOB.
1
2
CONTROL PANEL DECALS
CONTROL PANEL DECALS