Filter
Top Products
LS60TD AND LS600 — CONTROL BOX REPLACEMENT — REV. #1 (03/23/12) — PAGE 5
CONTROL BOX PROGRAMMING
See Figure 7 to identify control box switches.
Figure 7. Control Box Switches
Language Selection
1. Turn the IGNITION switch to the ON position. Do not
start engine.
2. Place the FLOW DIRECTION switch to reverse.
3. Place the AUTOMATIC/JOG switch to jog.
4. Place the CONTROL switch to remote.
5. Manually hold the CYLINDER STROKE switch to the
jog B position. While holding the switch to the jog B
position, toggle the RESET switch down 5 times. On
the fifth time, the digital screen will display the current
set language. Toggle RESET switch again to change
language, if desired.
NOTICE
Control boxes come pre-programmed from the factory
and configured to Model LS300. It is necessary to
reprogram the model configuration to match your unit.
RESET
SCROLL
SET
VOLUME
FLOW
DIRECTION CONTROL
DECREASE INCREASE
FORWARD REVERSE LOCAL
IGNITION
REMOTE
OFF
ON
START
CENTER
OFF
AUTOMATIC JOG
JOG “A” JOG “B”
CYLINDER STROKE
MULTIQUIP INC. CARSON, CALIFORNIA 90746 USA
310-537-3700 800-421-1244 WWW.MULTIQUIP.COM
Digital Screen
Ignition Switch
Reset Switch
Control Switch
Automatic/Jog
Switch
Flow Direction
Switch
Cylinder Stroke
Switch
6. Once the language is selected, place the CONTROL
switch to the center off position.
7. Turn the IGNITION switch to OFF then ON again to
memorize final configuration.
Machine Model Configuration
1. Turn the IGNITION switch to the ON position. Do not
start engine.
2. Place the FLOW DIRECTION switch to reverse.
3. Place the AUTOMATIC/JOG switch to jog.
4. Place the CONTROL switch to remote.
5. Manually hold the CYLINDER STROKE switch to the
jog B position. While holding the switch to the jog B
position, toggle the RESET switch down 5 times. After
the fifth time, move the CYLINDER STROKE switch
to the jog A position. While holding the switch to the
jog A position, toggle the RESET switch down to the
desired model (LS60TD or LS600).
6. Once the model is selected, place the CONTROL
switch to the center off position.
7. Turn the IGNITION switch to OFF then ON again to
memorize final configuration.