Mr. Heater MH4BC Automobile User Manual


 
5
Operating Instructions and Owner’s ManualMr. Heater MH4B | Base Camp MH4BC
TROUbLESHOOTING INFORMATION:
If Spark electrode does not produce spark.
CHECK
Spark electrode broken – replace.
Igniter wire may not be attached to spark
electrode.
Igniter wire damaged – replace.
Piezo igniter defective – replace regulator valve
assembly.
If Spark electrode produces spark but pilot does not light.
CHECK
No gas to heater – re-install or replace gas
cylinder.
Pilot is blocked from spider web or dirt – clean
pilot, see MAINTENANCE.
If Pilot flame does not stay lit when button is released.
CHECK
“Pilot/Ignition” button not held long enough
to purge air from line.
Pilot ame not surrounding thermocouple –
clean pilot, see MAINTENANCE.
Pilot Assembly defective – replace.
• Tip switch wires disconnected – connect
tip switch (check off switch and off switch
wiring).
If Main burner does not ignite.
CHECK
Main burner orice is blocked – clean burner,
see MAINTENANCE.
If Heater keeps shutting “OFF” during normal operation.
CHECK
Pilot is blocked – clean pilot, see
MAINTENANCE.
Provide minimum fresh air opening of 4 square
inches (example 2” x 2” opening).
Tip over switch activated from bumping heater.
Re-light
—INTENTIONALLY LEFT bLANK