Metra Electronics GMLAN11-100 Automobile Accessories User Manual


 
*Important: Before beginning any of the following,
disconnect the negative battery terminal to prevent an
accidental short circuit.
INSTALLING THE INTERFACE
From the 22 way harness:
Connect the Black wire with the ring terminal to the back of the aftermarket radios chasis
Connect the 3.5mm jack to your aftermarket radios steering wheel control input (if
equipped)
From the 30 way harness:
Connect the Black wire to the ground wire of the aftermarket radio
Connect the RCA’s on 8 pin harness to the AUX in on the aftermarket radio (if equipped)
The XIA-LCD is need to view Satellite stations (sold separately)
Connect the Yellow wire to the constant wire of the aftermarket radio.
The GMLAN11-100 comes set up for amplied systems. If the vehicle is not amplied
disconnect the 4 pin harness located between the 30 way and 22 way connector.
Connect the supplied 4 pin speaker harness and connect the following:
Connect the Violet wire to the right rear positive wire of the aftermarket radio
Connect the Violet/Black wire to the right rear negative wire of the aftermarket radio
Connect the Green wire to the left rear positive wire of the aftermarket radio
Connect the Green/Black wire to the left rear negative wire of the aftermarket radio
INSTALLING THE GMLAN11-100
With all the connections completed, plug the 20, 22, and 8 pin harnesses into the GMOS-
100i (sold separately).
1