Filter
Top Products
• Long ashes represent the wire(s) that are connected to the interface
• 3rd led ash is the Green/Orange wire on the interface
• 5th led ash is the Black/Green wire on the interface
If during the auto detect sequence there was no long led ash, just
short ones, the interface was not connected to the correct wire on the
ASWCSTALK or the incorrect wire was used on the interface.
The 2nd set of led ashes represents what brand radio the interface
believes it is connected to. Each ash is for a different radio manufacturer.
For example if you are installing a JVC radio the interface should blink 5
times.
1st led ash is for Eclipse
2nd led ash is for Kenwood
3rd led ash is for Clarion
4th led ash is for Sony and Dual
5th led ash is for JVC
6th led ash is for Pioneer and Jensen
7th led ash is for Alpine*
8th led ash is for Visteon
9th led ash is for Valor
10th Clarion 5V
* Note: If the interface ashes 7 times and you do not have an Alpine
radio connected to it that means that the interface did not see any radio
connected. Verify the 3.5mm connector is connected to the SWC input on
the radio.
5