Filter
Top Products
2
Locate the factory wiring harness
in the dash. Metra recommends
using the proper mating adapters
from Metra and AXXESS to inte-
grate your new radio. Re-connect
the negative battery terminal and
test the unit for proper operation.
Attach the Double DIN brackets to
the Double DIN trim plate. (Fig. A)
Slide the Double DIN head unit or
stacked ISO head units into the
bracket/radio housing assembly
and secure the Double DIN head
unit or stacked ISO head units to
the assembly using the screws
supplied with the radio. (Fig. B)
Using an air saw, hacksaw, or simi-
lar cutting tool, cut to the inside of
the radio’s lower mounting holes,
through the plastic and metal
bracket. (Cut on the inside of each
hole as close to the hole as you
can get. If cut properly you may re-
use two bottom factory screws, if
not use self tapping screws on the
bottom.) (Fig. C)
Reassemble dash in reverse order
of disassembly.
95-8904B KIT ASSEMBLY
1
2
3
4
5
DDIN / STACKED ISO
HEAD UNIT PROVISION
A
B
C
NOTES
95-8904B
2010 SUBARU LEGACY / OUTBACK