Filter
Top Products
95-7510 FINAL ASSEMBLY
FINAL ASSEMBLY
(A) Strip wire ends back 1/2"
B) Twist ends together
C) Solder
D) Tape
A
B
C
D
5
FINAL WIRING CONNECTIONS
METRA / EIA WIRING CODE
12V Ignition / Acc. . . . . . Red
12V Batt / Memory. . . . . Yellow
Ground . . . . . . . . . . . . . . Black*
Power Antenna. . . . . . . . Blue
Amp Turn-On . . . . . . . . . Blue / White
Amp Ground . . . . . . . . . . Black / White
Illumination . . . . . . . . . . Orange
Dimmer. . . . . . . . . . . . . . Orange / White
Right Front (+) . . . . . . . . Gray
Right Front (-). . . . . . . . . Gray/ Black
Left Front (+) . . . . . . . . . White
Left Front (-). . . . . . . . . . White / Black
Right Rear (+). . . . . . . . . Violet
Right Rear (-) . . . . . . . . . Violet / Black
Left Rear (+). . . . . . . . . . Green
Left Rear (-) . . . . . . . . . . Green / Black
*NOTE: When a Black wire is not present, ground radio to vehicle chassis.
All colors may not be present on all leads due to manufacturer’
s specifica
tions.
1
Locate the factory wiring harness in the dash. Use the supplied wire harnesses and
make the connections as shown. (Isolate and individually tape off the ends of any
unused wires to prevent electrical short circuit). Refer to Metra/EIA Wiring Code
below.
Make wiring connections using the EIA color code chart shown below and the
instructions included with the head unit. Metra recommends making connections as
shown below; Strip, Splice, Solder, Tape. Isolate and individually tape off ends of any
unused wires to prevent electrical short circuit.
Continued on Page 6