Filter
Top Products
96
5 Remove the protective cover from
the jack support tube opening by
inserting a screwdriver in the
opening and prying it out. The tube
openings are located directly
behind the front wheel housings
and in front of the rear wheel
housings.
6. Insert jack arm fully into the
tube hole up to the stop. Place
jack on firm ground. Position
the jack so that it is always
vertical (plumb-line) as seen
from the side (see arrow), even
if the vehicle is parked on an
incline.
7. Jack up the vehicle until the
wheel is clear of the ground.
Never start engine while vehicle
is raised.
8 Unscrew wheel bolts completely.
Keep bolt threads protected from
dirt and sand. While removing the
last bolt, hold wheel against hub
to avoid paint damage on rim,
9 Remove wheel.
10 Screw the alignment bolt (1)
supplied in the tool kit into the
upper-most threaded hole