Filter
Top Products
or open a side window slightly to reduce or
eliminate these noises.
Operating the tilt/sliding sunroof
Opening and closing
i
You can still operate the tilt/sliding
sunroof even if you switch off the engine or
remove the SmartKey. This function
remains active for five minutes or until one
of the front doors is opened.
Overhead control panel
:
To raise
;
To open
=
To close
X
Switch on the ignition.
X
Push or pull the 3 switch in the
corresponding direction.
i
If you press the 3 switch beyond the
point of resistance, an automatic opening/
closing process is started in the
corresponding direction. You can stop
automatic operation by pressing again.
Automatic opening/raising is only available
if the tilt/sliding sunroof is in the closed
position.
You can open/close the cover for the
sunblind manually when the tilt/sliding
sunroof is raised/closed.
Resetting
Reset the tilt/sliding sunroof if it does not
open smoothly.
!
Contact a qualified specialist workshop if
the tilt/sliding sunroof cannot be closed
fully or reset.
X
Switch on the ignition.
X
Raise the tilt/sliding sunroof fully at the
rear (Y page 97).
X
Keep the 3 switch pressed for another
second.
X
Make sure that the tilt/sliding sunroof can
be opened or closed fully again using the
opening/closing process (Y page 97).
X
If the tilt/sliding sunroof can be raised fully
at the rear it is set correctly. If this is not
the case, you must repeat the previously
described steps.
Operating the panorama sliding
sunroof
Opening and closing
Overhead control panel
:
To raise
;
To open
=
To close
The panorama roof with power tilt/sliding
panel can only be moved when the roller
sunblinds are open.
Sliding sunroof
97
Opening and closing
BA 212 USA, CA Edition B 2011; 1; 5, en-US
dimargi Version: 3.0.3.6
2010-05-20T13:33:46+02:00 - Seite 97
Z