Filter
Top Products
Useful features
194
Programming the integrated remote
control
X
Step 1: Switch on the ignition.
X
Step 2: If you have previously programmed
a signal transmitter button and wish to
retain its programming, proceed to step 3.
or
X
If you are programming the integrated
remote control for the first time, press and
hold the two outer signal transmitter but-
tons 2 and 4 and release them only when
indicator lamp 1 begins to flash after
approximately 20 seconds (do not hold the
button for longer than 30 seconds).
This procedure erases any previous set-
tings for all three channels and initializes
the memory. If you later wish to program a
second and/or third hand-held transmitter
to the remaining two signal transmitter but-
tons, do not repeat this step and begin
directly with step 3.
X
Step 3: Hold the end of hand-held remote
control 5 of the device you wish to train
approximately 2 to 12 in (5 to 30 cm) away
from the signal transmitter button (2, 3
or 4) to be programmed, while keeping
indicator lamp 1 in view.
X
Step 4: Using both hands, simultaneously
press hand-held remote control button 6
and the desired signal transmitter button
(2, 3 or 4). Do not release the buttons
until step 5 is completed.
Indicator lamp 1 will flash, first slowly and
then rapidly.
i
Indicator lamp 1 flashes immediately
the first time the signal transmitter button
is programmed. If this button has already
been programmed, the indicator lamp will
only start flashing after 20 seconds.
X
Step 5: After indicator lamp 1 changes
from a slow to a rapidly flashing light,
release the hand-held remote control but-
ton and the signal transmitter button.
X
Step 6: Press and hold the just-trained sig-
nal transmitter button (2, 3 or 4) and
observe indicator lamp 1.
If indicator lamp 1 stays on constantly,
programming is complete and your device
should activate when the respective signal
transmitter button (2, 3 or 4) is pressed
and released.
i
If indicator lamp 1 flashes rapidly for
approximately 2 seconds and then turns to
a constant light, continue with program-
ming steps 8 through 12 as your garage
door opener may be equipped with the
“rolling code” feature.
X
Step 7: To program the remaining two sig-
nal transmitter buttons, repeat the steps
above starting with step 3.
Rolling code programming
To train a garage door opener (or other rolling
code devices) with the rolling code feature,
follow these instructions after completing the
“Programming” portion (steps 1 through 6) of
this text. (A second person may make the fol-
lowing training procedures quicker and eas-
ier.)
X
Step 8: Locate the “training” button on the
garage door opener motor head unit.
i
Exact location and color of the button may
vary by garage door opener brand. Depend-
ing on manufacturer, the “training” button
may also be referred to as “learn”or
“smart” button. If there is difficulty locating
the transmitting button, refer to the garage
door opener Operator’s Manual.
X
Step 9: Press the “training” button on the
garage door opener motor head unit.
The “training light” is activated.
Controls in detail