Filter
Top Products
106
Controls in detail
Memory function*
Storing parking position
̈ Stop the vehicle.
̈ Switch on ignition (if not already on).
̈ Press button 2.
The passenger-side exterior rear view
mirror is selected.
̈ Adjust the exterior rear view mirror
with button 3 so that you see the rear
wheel and the road curb.
̈ Press memory button 2 (୴ page 105).
̈ Within three seconds, press bottom of
adjustment button 3.
The parking position is stored if the
mirror does not move.
Storing positions in memory
̈ Adjust the seat (୴ page 37) and exteri-
or rear view mirrors (
୴ page 40) to the
desired position.
̈ Push memory button 2 (୴ page 105).
̈ Release memory button and press one
of the position buttons 1 within three
seconds.
All the settings are stored at the select-
ed position.
Recalling positions from memory
̈ Press and hold one of the position
buttons 1 until seat and rear view mir-
rors have fully moved to the stored po-
sitions.
i
If the mirror does move, repeat the
above steps. After the setting is stored
you can move the mirror again.
The selected position will be stored rel-
ative to the position button 1
(
୴ page 105) pressed.
!
Do not operate the power seats using
the memory button if the seat backrest
is in an excessively reclined position.
Doing so could cause damage to front
or rear seats.
i
Releasing the button immediately
stops movement to the stored posi-
tions.