Filter
Top Products
- 6 -
4. Once the Pass-Key has been entered
and accepted the LED (7) will be lit
continuously. This confirms that the
Motorola RAZR phone is paired and
connected and the Motorola RAZR phone
’s
identity information has been stored in the
Mercedes-Benz V3 Cradle.
5. The Motorola RAZR phone is now ready
for use with the Mercedes-Benz Hands-Free
Communication System.
Establishing a Bluetooth
®
connection
Notes
A maximum of 4 Motorola RAZR phones can
be paired with the Mercedes-Benz V3
Cradle. However, only one Motorola RAZR
phone is connected to the Mercedes-Benz
V3 Cradle at a time. If a fifth Motorola RAZR
phone is paired with the Mercedes-Benz V3
Cradle, then the information stored from the
first Motorola RAZR phone which was paired
with the Mercedes-Benz V3 Cradle will be
replaced.
When the starter switch is in position 1, 2
or 3 (see the Vehicle Operator
’s Manual),
the Mercedes-Benz V3 Cradle will search for
the last connected Motorola RAZR phone
and reconnect.
The Mercedes-Benz V3 Cradle will search
continuously and automatically after start-
up for one of the paired phones.
If the last connected Motorola RAZR phone
is not found the Mercedes-Benz V3 Cradle
will search for one of the previously paired
phones and connect to it.
The searching routine is being repeated as
long as a paired RAZR mobile phone is ready
to be connected. Searching is indicated with
LED (7) flashing periodically.
Cradle_USA.fm Seite 6 Mittwoch, 20. September 2006 3:31 15