Filter
Top Products
Black plate (284,1)
9. Say: [Beep] “XXXX” (Speak an
arbitrary 4-digit pairing code. This can
be any combination of 4 numbers.)
NOTE
l
Some devices accept only a particular
pairing code (Usually, “0000” or “1234”).
If pairing cannot be completed, refer to the
owner's manual of your mobile device, and
try those numbers if necessary.
l
Record the code as it will be used to
program your phone in Step 16.
10. Prompt: “Pairing code XXXX (4-
digit number). Is this correct?”
11. Say: [Beep] “Yes” or “No”
12. If “Yes”, go to Step 13.
If “No”, the procedure returns to Step
8.
13. Prompt: “Start pairing procedure on
phone. See phone's manual for
instructions.”
14. Using the mobile telephone, perform
a search for the Bluetooth device
(Peripheral device).
NOTE
For the operation of the mobile telephone,
refer to its instruction manual.
15. Select “Mazda” from the device lis t
searched by the mobile phone.
16. Input the 4-digit pairing code set in
Step 9 to the mobile telephone.
17. Prompt: “Please say the name of the
phone after the beep.”
18. Say: [Beep] “XXXX - - -” (Speak a
“phone tag”, an arbitrary name for the
phone.)
Example: “Stan's phone.”
NOTE
Speak a programmed “phone tag” within 10
seconds.
If more than two mobile telephones are to be
programmed, they cannot be programmed with
the same or similar “phone tag”.
19. Prompt: “Adding XXXXXX - - -
(Ex. “Stan's phone”) (Phone tag). Is
this correct?”
20. Say: [Beep] “Yes”
21. Prompt: “Assign a priority for this
phone between 1 and 7, where 1 is
the phone used most often .”
22. Say: [Beep] “1” (Speak a number of
the desired priority from 1 to 7.)
NOTE
l
Normally, “1” is to be input (Highest
priority).
l
If more than two mobile telephones are
registered, input the priority order from 1 to
7.
23. Prompt: “XXXXXX - - - (Ex.
“Stan's phone”) (Phone tag) set to
priority X (Priority number). Is this
correct?”
24. Say: [Beep] “Yes”
25. Prompt: “Pairing complete”
After a mobile telephone is registered, the
system automatically identifies the phone.
By pressing the voice recognition/hands-
free switch again, or by pressing the voice
recognition/hands-free switch first after
turning the ignition switch from the
LOCK to the ACC posit ion, the system
reads out a voice guidance, “XXXXXX -
- - (Ex. “Stan's phone”) (Phone tag) is
connected”. If two or more telephones are
registered, the one with the highest
priority is selected.
6-66
Interior Comfort
Bluetooth Hands-Free
MX-5_8AV1-EA-09F_Edition2 Page284
Thursday, July 30 2009 2:45 PM
Form No.8AV1-EA-09F