Mazda 2010 CX-7 Manual

next previous

3 4

To Program the Driver’s Seat Position

1 Parkvehicle.

2 AdjustseattodesiredpositionusingtheSlide/TiltandReclineswitches.

3 WhileholdingtheSETbuttonin,pushoneofthethree(3)programming

buttonsuntilabeepisheard.Programmingisnowcomplete.Program

remainingtwobuttonsasdesired.

NOTE: Youcanalsoprogramoneseatpositionforeachadvancedkey/retractable

typekeyusedwiththevehicle.SeeOwner’sManualforprogramminginstructions.

To Move the Seat to a Programmed Position

 •  With driver’s door OPEN and ignition OFF,pushandreleaseone

oftheprogrammedbuttons(1,2,or3)whenenteringthevehicle.

 •  With driver’s door CLOSED and ignition ON,pushandholdoneof

theprogrammedbuttons(1,2,or3).

NOTE:

MemoryseatfunctionsDONOToperatewhendriver’sdoorisOPENand

ignitionisON,whendriver’sdoorisCLOSEDandignitionisOFF,orwhenthevehicle

isinmotion.

ELECTRONICALLY OPERATED DRIVER SEAT CONTROLS

Returning second-row seats to upright position

1 Raiseseatbacksuntiltheylockintoposition(redindicatorisnot

  visiblewhenseatisinthelockedposition).

2 Pullonthetopoftheseatbacksfrominsidethevehicle

tomakesuretheyarelocked.

3 Checkthatallseatbeltsareroutedproperlyforpassengeruse.

Seatback Knob

Slide/Tilt Switch

Seatcanbemoved

backandforth,raised,

lowered,ortiltedwith

thiscontrol.

Recline Switch

Pushforwardorbackward

toadjustseatbackangle.

Memory Seat Switch

FOLDING SECOND-ROW SEATS

1 Unfastenthelapportionoftherearcenterseatbelt.

2 Supporttheseatbackwithyourhand.

3 Pushtherearseatbackknobdown(redindicatorisvisiblewhen

  seatisintheunlockedposition).

4 Bringtheseatbackforward.

Seats

211069_10b_Mazda_CX-7_SSG_063009.indd 4-5 6/30/09 3:52:30 PM