Filter
Top Products
Black plate (275,1)
qChanging Coolant (Without Rear
Heater)
Change coolant according to Scheduled
Maintenance (page 8-3).
CAUTION
l
Use only soft (demineralized) water
in the coolant mixture. Water that
contains minerals will cut down on
the coolant's effectiveness.
l
Don't add only water. Always add a
proper coolant mixture.
l
The engine has aluminum parts and
must be protected by an ethylene-
glycol-based coolant to prevent
corrosion and freezing.
l
DO NOT USE coolants Containing
Alcohol, methanol, Borate or
Silicate.
These coolants could damage the
cooling system.
l
DO NOT MIX alcohol or methanol
with the coolant. This could damage
the cooling system.
l
Don't use a solution that contai ns
more than 60% antifreeze.
This would reduce effectiveness.
NOTE
If the “FL22” mark is shown on or near
the cooling system cap, use FL22 type
engine coolant. If engine coolant other
than FL22 type is used, the engine
coolant must be replaced earlier than
the specified replacement interval
indicated in the scheduled maintenance
(page 8-3).
Except FL22 type
For mixture percentage:
Protection
Volume
Antifreeze
solution
Deminera-
lized water
Above
_
16°C (3°F) 35% 65%
Above
_
26°C (
_
15°F) 45% 55%
Above
_
40°C (
_
40°F) 55% 45%
FL22 type
FL22 type engine coolant concentration is
factory adjusted. Use the product as it is
without diluting it.
Maintenance and Care
Owner Maintenance
8-15
Mazda MPV_8U61-EA-05G_Edition1 Page275
Tuesday, June 21 2005 9:38 AM
Form No.8U61-EA-05G