Filter
Top Products
SEATS
Always check the Owner’s Manual for more operating information and safety features
Seats
Seats
Quick Tips 2001 Mazda Millenia page 12
page 13
Revised January 9, 2001
1. Head restraint
To raise/lower: Press release
button (4) and pull up/
push down
To move forward/aft: Rotate
(driver’s seat only)
Power seats
2. Raise/lower front of seat
Move front of switch vertically
Fore/aft adjustment
Move switch horizontally
Raise/lower rear of seat
Move rear of switch vertically
Raise/lower seat cushion
Move center of switch vertically
3. Seatback angle
Rotate fore/aft for desired angle
Lumbar support
(driver’s seat only)
Located at front of
center console
Press top/bottom of switch to
increase/decrease firmness
WARNINGS: Always wear
your safety belt and properly
secure children 12 and under
in the rear seat
If you choose to install a
forward-facing child restraint
seat, move vehicle seat as
far back as possible
Air bag is supplemental
and does not replace safety
belt usage
Do not adjust seat while driving
1
4
2 3
1
Shoulder belt height
adjustment
To raise/lower belt, press
button (1) and move up/down
WARNING: Make sure
adjuster locks in position
WARNINGS: Children less
than 4 years old and under
40 pounds should always
use a safety seat
Never place rear-facing child
restraint seat in front seat
Child restraint seat
Some child restraint systems are
equipped with tethers that must
be installed on one of the three
anchors on the rear seats
To install in rear outboard seats:
Use dual locking mode retractor
safety belt; see Owner’s Manual
for proper installation and child
seat tether instructions
WARNING: Read all
information and warnings
in Owner’s Manual and
attached to seat before using
child safety seat
Dual locking mode
lap/shoulder belt retractor
(front passenger and rear
outboard safety belts only)
Emergency locking mode: Belt
locks only on hard braking/
cornering or impacts of about
5 mph or more
Automatic locking mode:
Must be used when installing
child safety seat
To activate: Pull webbing fully
out of retractor until click is
heard; belt will only tighten
To disengage: Unbuckle belt and
allow webbing to retract fully