Filter
Top Products
5
The remote starter can be programmed to start the engine every 2 or 3 hours. The engine will run
for the programmed run time and then shut down. This feature is designed for an extremely cold
climate, preventing the engine from being hard to start or freezing over. A MAXIMUM OF SIX
CYCLES CAN OCCUR.
Important: Timer start should be used in open areas, never start and run the vehicle in enclosed
spaces as a garage or carport.
To Activate the Start Timer:
1. Press the button twice within 3 seconds to remote start the vehicle.
2. As soon as the vehicle is running and the parking lights have turned on or are flashing.
immediately depress the button.
3. Press the button within 2 seconds. The parking lights will flash 3 times. The siren or horn
will chirps 3 times. The vehicle is now programmed to start every 3 hours.
Note: Unless the installer of this remote start system has reprogrammed the start timer for a 2
hour duration, the default programmed start time is set to 3 hours.
Exit the Timer Start:
Timer start can be exited manually as follows:
1. Make sure the remote start system is not operating the engine.
2. Turn the ignition On. The parking lights will flash 4 times. The horn will chirp 4 times.
OR
1. Press the button twice within 3 seconds to remote start the vehicle.
2. As soon as the vehicle is running and the parking lights have turned on or are flashing,
immediately depress the button.
3. Then press and hold the button for 2 seconds. The parking lights will flash 4 times. The
siren or horn chirps 4 times. The vehicle is no longer programmed to start automatically.
Timer Start
Turbo Timer Mode
(Also See Installation Manual)
Turbo Timer Mode keeps the engine running after arriving at your destination for a programmable
time period of 1, 3 or 5 minutes. This allows the system time to conveniently cool down the turbo
after you have left the vehicle.
To Activate:
1. While the engine is running, place the transmission in "Park" then set the emergency brake.
2. Before turning off the engine, press and release and buttons at the same time. The
parking light will turn on to indicate the remote start has entered turbo charge mode.
3. Remove the “Ignition Key” from the key cylinder. The engine will keep running.
4. Exit and secure the vehicle. The Engine will continue to run until the pre-programmed time has
elapsed.
M6A-UM 3/8/05 3:45 PM Page 5