Filter
Top Products
4
Valet/Override Switch Operation
Disarming The Security System Using the Passive Transmitter
(M5 Security System only)
A. The passive transmitter may be used as a normal transmitter and/or as a passive transmitter.
B. For passive unlocking/disarm operations to operate, the slide switch must be in the ”on” position.
C. With the security system armed, walk toward your vehicle and the security system will respond
the same as pushing the unlock button on the transmitter.
D. Anytime the passive-unlocking/disarm feature is not desired move the switch to ”off” position.
Operation Notes:
For total passive operations and conveniences, the security system alarm receiver
module should
be programmed for both Automatic Arming and with Automatic Door Locking. This will allow the
security system to automatically arm as you exit and to automatically disarm as you approach the
vehicle. The vehicle will remained disarmed and unlocked while you are moving near the vehicle.
After the passive disarm signals disappears the system will begin auto arming again etc.
With the auto arming and auto locking feature programmed on, the vehicle will re-arm and re-lock
the doors 45 seconds after the last passive disarm signal was received.
When you manually depress the Lock/Arm button on the passive transmitter, after exiting the
vehicle, the alarm receiver module will not respond to a passive disarm signal for 60 seconds.
This avoids unwanted disarm/unlocking as you walk away from the vehicle.
Warning- The security system will not re-arm or re-lock the doors unless the auto arming and
auto re-locking features are programmed “On”. If you do not want passive arming/locking
features programmed On, we suggest you always keep the passive slide switch turned off.
The security system is now disarmed!
Disarming the Security System Using the Transmitter
The valet switch is used to override the security system in the event that the transmitters are lost or
fail to operate and to put the security system in non-operational mode (valet) for vehicle servicing etc.
Override Operation: (Security System is Armed)
1. Enter the vehicle (The security system will begin sounding at this point)
2. Place the ignition key into the ignition switch and turn the ignition switch to the “on” position.
3. Within 5 seconds of turning the ignition key “on”, place the valet switch to the “on” position.
4. The horn/siren will stop sounding.
5. The LED indicator will be solid red.
The security system is overridden and is now in the valet mode!
Note
1: If the valet switch is already in the “on” position when you turn “on” the ignition key, the
override function will be bypassed. Turn “off” the ignition key, place the valet switch in the “off”
position and try again.
Note 2: If you fail to place the valet switch to the “on” position within 5 seconds of turning “on” the
ignition key, the override function will be locked out. Place the valet switch in the “off” position, turn
“off” the ignition key and try again.