Filter
Top Products
3
Program a User Code
To Program the User Code, Repeat the Following Steps:
1. All vehicle security systems must be in disarmed mode prior to tap-code programming.
2. Decide what your new user code will be before starting the programming sequence. The user code
must be a minimum of (3) digits and a maximum of (5) digits.
Note: Default user code is 11111.
3. Set the ignition key from the “Off” position to On - Off - On (Ignition is on).
4. Press and release the black rubber button on the tap sensor (3) times.
5. In an area close to the tap sensor, tap the vehicle glass (2) times. The tap sensor will flash “0” - “0”
and then start to display digits from 1-5.
6. Tap on the glass (1) time when the first digit of your unlock code is shown. The digit will flash twice to
confirm that it has been selected. The tap sensor will start to display numbers from 1 to 5 again. Tap
on the glass (1) time for each remaining digit of your user code.
7. When you are done “tap-selecting” your user code, set the ignition key to the Off position. The tap
sensor will flash “0” - “0” and then display the new code you have entered. The tap sensor will repeat
the “0” - “0” flash and display the new code a second time.
Recalling the Programmed Tap Code
In the event you forgot your tap code, repeat the following procedure to recall the programmed tap-code:
1. Set the ignition key from the “Off” position to On - Off - On (Ignition is on).
2. Press and release the black rubber button on the tap sensor (6) times.
3. The tap sensor will display the current tap-code starting with “0” - “0”. The code will be displayed
twice.
To Unlock Your Vehicle
1. Tap on the vehicles windshield near the location of the tap sensor 2 times. The tap sensor will display
“0” - “0” and then will start to display numbers from 1 to 5, pausing for 1 second between each
number.
2. Tap on the glass 1-time when the first digit of your unlock code is shown. The digit will flash twice to
confirm that it has been selected.
3. The tap sensor will start to display numbers from 1 to 5 again. Tap on the glass 1- time for each
remaining digit of your user code.
4. When the correct code has been “tap-selected”, the display will show “C” and the doors will unlock.
5. If a mistake was made in the digit selection process, the display will show “E” and start displaying
numbers from 1 to 5 again. Repeat steps 2-3.
6. The following unsuccessful code entry attempts will lock the tap sensor out for 1 minute:
If your code is 3 digits, 3 unsuccessful attemps,
If your code is 4 digits, 4 unsuccessful attemps,
If your code is 5 digits, 5 unsuccessful attemps.
Note: Cycling the ignition key on-off will reduce this time.