Filter
Top Products
9
www.magellangps.com
Adjusting the Mount for Optimum Viewing
Loosen the adjustment locking knob and position the Magellan RoadMate receiver for optimum
viewing. Once set, tighten the locking knobs. (Never attempt to adjust the mount while driving.)
Connecting Power
Plug the end of the vehicle power adapter into
a 12VDC vehicle power receptacle. Connect the
other end of the cable to the Magellan RoadMate
receiver’s power connector as shown.
Note: Some vehicles apply power to the vehicle
power receptacle only when the ignition is on.
Checking Connection and Final Adjustments
If the power indicator light on the vehicle power
adaptor is on, power is being supplied to the
Magellan RoadMate receiver. If it is not on, check
the cable connection to the vehicle power receptacle. If the light is still not on, turn the vehicle’s
ignition on.
Power Switch
Slide the power switch to the left turn the receiver on. Slide the power switch to the center
position to turn the receiver off. (Slide the power switch to the right to reset. [Power Reset] can
sometimes solve any problems encountered while using the receiver.)
Security
It is recommended that the Magellan RoadMate receiver is not left in plain view while unattended
for reasons of theft.
Please note that the Magellan RoadMate receiver is a receiver only and does not transmit GPS
location signals. Neither the receiver nor the vehicle can be tracked using the Magellan RoadMate
receiver.