Filter
Top Products
4
Attaching the Magellan RoadMate receiver to the Car Cradle
Slide the Magellan RoadMate receiver on the car cradle so that the slot on the
Magellan RoadMate receiver aligns with the tab on the car cradle. Slide the
Magellan RoadMate receiver all the way down until it rests on the 'feet'. You should
notice a click when the receiver is fully mounted in the cradle.
Adjusting the Mount for Optimum Viewing
Loosen the adjustment locking knobs and position the Magellan RoadMate receiver
for optimum viewing. Once set, tighten the locking knobs. (Never attempt to adjust
the mount while driving.)
Connecting Power
Plug the end of the vehicle power adapter into a 12VDC vehicle power
receptacle. Connect the other end of the cable to the Magellan RoadMate
receiver's power connector as shown.
Note: Some vehicles apply power to the vehicle power receptacle only
when the ignition is on.
Routing the Cable
Route the cable behind the Magellan RoadMate receiver as shown. Lock the cable into the cable retainer.
Checking Connection and Final Adjustments
If the power indicator light on the vehicle power adaptor is on, power is being supplied to the Magellan RoadMate
receiver. If it is not on, check the cable connection to the vehicle power receptacle. If the light is still not on, turn
the vehicle's ignition on.
Slide the power switch (located at the top right side of the Magellan RoadMate receiver) to the left. Sit in a
normal driving position and make any final adjustments to the car cradle for optimum viewing. Make sure the
adjusting knobs on the car cradle are firmly in place.
Slide the power switch again to the right to turn the Magellan RoadMate receiver off and turn the ignition switch
of the vehicle to off. The Magellan RoadMate receiver is connected and ready for use.