Filter
Top Products
108
iFINDER
HUNT Quick Reference
Start outdoors, with a clear view of the open sky. As you practice, try
navigating to a location a few blocks away. Navigation in too small a
space, like a backyard, will constantly trigger arrival alarms.
1. Install two AA batteries (and MMC card if desired) in battery com-
partment on back of case. (See installation details beginning on page 11.)
2. To turn on iFINDER HUNT, press and release
PWR key.
3. Opening screen displays map of North America at the 4,000 mile
zoom range. Rotate through the two main Page screens (Map Page,
Compass Page) by repeatedly pressing
PAGES key; switch Pages to dis-
play Map Page.
4. Wait while unit locates satellites and calculates current position. Flash-
ing question mark or data boxes indicate a position has not been deter-
mined. Position calculation takes an average of one minute or less under
clear sky conditions (unobstructed by terrain or structures.) When position
is found, a tone sounds, a position acquired message appears, data boxes
stop flashing and the flashing question mark disappears.
5. With position acquired, the Map Page shows your location on the
map in a bird's eye view of the earth. You can move around the map by:
Zoom in closer to see greater detail: press
ZIN (zoom in key.)
Zoom out to see more area, less detail: press
ZOUT (zoom out key.)
Scroll map north, south, east or west using arrow keys ↑ ↓ → ←.
To stop scrolling and return to current position on map, press
EXIT key.
6. Set a Car waypoint at your current position so you can navigate back
here: press
ENT|ENT|ENT. Waypoint Car(1) will appear on the map.
7. Zoom/scroll map to find a nearby object or location. Use arrow keys to
center cursor cross-hair over the map object or location.
8. To navigate to the selected location: press
MENU|ENT|EXIT. Follow
steering arrow on Map Page or compass bearing arrow on Compass Page.
9. At destination, Arrival Alarm goes off; to clear it, press
EXIT. Cancel
navigation: press
MENU|↓ to CANCEL NAVIGATION|ENT|← to YES|ENT.
10. Navigate back home: Zoom/scroll map and use arrow keys to center
cursor cross-hair over waypoint Car(1). Press
MENU|ENT|EXIT and fol-
low steering indicators.
11. Back home, Arrival Alarm goes off; press
EXIT. Cancel navigation:
press
MENU|↓ to CANCEL NAVIGATION|ENT|← to YES|ENT.
12. To turn off iFINDER, press and hold
PWR key for three seconds.