Filter
Top Products
49
The 15-mile zoom figure (left) clearly shows the dotted course line con-
necting your current position to your destination. The 40-mile zoom
(center) shows both current position and destination on screen. The
Navigation Page (right) will also show navigation information.
To stop navigating to the cursor, use the Cancel Navigation command:
press
MENU|MENU|↓ to CANCEL NAVIGATION|ENT|← to YES|ENT. The unit
stops showing navigation information.
Navigate to a Point of Interest
For POIs that are in view on the map, you can easily use the Navigate
to Cursor command above; just use the cursor to select the POI.
The other method involves searching for POIs with the Find Waypoint
command, launched with the
WPT key
To Navigate to a POI:
1. Press
WPT, select the desired POI category, then press → to Subcate-
gory.
2. Highlight the desired subcategory and press
ENT. The Find By menu
will appear with two search options: Name of Nearest.
3. Select the desired search option and press
ENT. A list of POIs will
appear. If you chose Nearest as the search option, use ↑ ↓ to select the
desired POI and press
ENT. If you chose to search by Name, use ↑ ↓, ←
→ to input the POI name. When the name has been entered press
ENT
to access the POI list.
4. Select the desired POI and press
ENT, which will open the Waypoint
Information menu.
5. Highlight
GO TO WAYPOINT and press ENT. The unit begins showing
navigation information to the item.
To cancel navigation, press
MENU|MENU|↓ to CANCEL NAVIGATION|ENT|←
to
YES|ENT. The unit stops showing navigation information.