Lowrance electronic 000-10537-001 GPS Receiver User Manual


 
14 |
Display Installation | HDS Gen2 Touch Installation Manual
Mounting the transducer
Transducer location selection and installation are two of the
most critical steps in sonar installation. To function properly the
transducer must be in the water at all times, and in a location that
has a smooth ow of water when the boat is moving.
Research
Before starting the installation of the transducer, it’s advised to
check the following;
• Find out if the boat builder has a recommended installation location
• Establish direction of rotation of the propeller(s)
• Watch actual water ow when boat is travelling at cruising speed to
determine the area of transom with cleanest ow (least bubbles)
Select a transducer location
The primary aim is to stay clear of propeller and hull generated
turbulence, while mounting the transducer as close to the center of
the vessel as possible.
1
2
3
5
4
1 Avoid mounting within 1m (3.3’) to port of propeller
2 Conventional clockwise propeller rotation
3 Avoid mounting within 7.5cm (3“) to starboard of propeller
4 Best mounting location - undisturbed water ow
5 Planing strake - avoid mounting behind here
¼ Note: Reverse the distance guides (1 & 3) from propeller where
engine is of counterclockwise conguration.
4