Filter
Top Products
26 |
Software setup | HDS Gen2 Touch Installation Manual
Software setup
Sonar installation settings
Keel oset
This is a value that can be entered on the Sonar Installation page to
make depth readings relate to any point from the water surface, to
the deepest point of the vessel.
Below are some typical ways in which the oset is used:
A) For Depth below Keel: Set the distance from transducer to the
keel.
Enter a negative value, e.g.
B) For Depth Below Transducer: no oset required.
C) For Depth Below Surface (waterline): Set the distance from
transducer to the surface:
Enter a positive value., e.g.
A B C
6