Filter
Top Products
28 |
Software setup | HDS Gen2 Touch Installation Manual
Touch Screen Calibration
In some cases it may be required to re-calibrate the touch screen
due to electrical inuences on the device from it’s installation
environment. The following steps should be completed to apply
calibration:
1.
Turn the unit o
2. Press and hold the Waypoint key, then turn the unit on
3. Hold the Waypoint key during power on, until the calibration utility screen
comes up
4. Touch crosshair shown on screen to perform nine points calibration
5. After successful calibration the unit will return to normal application screen
Software upgrades
The latest software for this unit will be available for download from
the Lowrance web site;
www.lowrance.com
An SD card and SD reader/writer are required for this.
Detailed instructions for how to install the software are provided on
the update web page.