Filter
Top Products
Lotus Service Notes Section GF
Page 4
GF.2 - WINTER TYRES & SNOW CHAINS
If the car is to be used in very cold territories, or driven on snow covered roads, it is recommended to fit
winter tyres developed specifically for such conditions. Lotus approves the fitment of Michelin X M+S 130 winter
tyres in the following sizes:
Type Michelin X M+S 130
Size - front 185/55 R15 81T mounted on standard 15 inch front wheels.
- rear 195/60 R15 88T mounted on standard 15 inch front wheels.
Pressure (cold) - front 1.6 bar (23 lb/in²)
- rear 1.7 bar (24.5 lb/in²)
Note that the rear winter tyres are to be mounted on standard 15 inch front wheels rather than the standard 16
inch rear wheels.
WARNING:
- When winter tyres are fitted, a maximum speed of 118 mph (190 km/h) must be observed.
- The tyres are NOT suitable for studding.
Tyre Chains
Snow chains may by used in extreme conditions only in conjunction with winter tyres (see above) and
fitted only on the rear wheels. Lotus approves the fitment of Pewag FX 67 S Ring-Super-X snow chains,
available under Lotus part number A100G6011F. Close attention should be paid to the fitting and tensioning
instructions supplied with the chains, and an appropriate driving style adopted. The chains should be removed
as soon as road conditions allow.
GF.3 - EMERGENCY PUNCTURED TYRE INFLATOR
In order to fully exploit the benefits of light weight, and to maximise stowage space and convenience, a 'keep
you mobile' punctured tyre inflator aerosol is stowed in the front services compartment. When the aerosol is
connected to the tyre valve, and the button pressed, a mixture of liquid latex and propellant is injected into the
tyre, such that the solidifying latex is forced into the puncture site at the same time as the tyre is inflated,
effecting a temporary repair and enabling the car to be driven at moderate speed to the nearest tyre depot.
WARNING:
- Use of the aerosol does not constitute a permanent repair, but is designed to allow the car to be
driven to the nearest tyre depot. At the earliest opportunity, the tyre should be professionally
repaired or replaced dependent on the severity of the damage.
- Until the tyre is repaired or replaced, the car should be driven in a moderate manner, not exceed-
ing 30 mph (45 km/h).
- The aerosol should not be used for large holes or repairs, or when the tyre sidewall has been
damaged, or if the tyre has been displaced from the rim.
- The aerosol should be carried at all times in the stowage bracket provided in the front services
compartment; never in the passenger compartment.
Directions for use of the aerosol: As soon as a puncture is suspected, pull off the road at the first safe opportu-
nity. If possible avoid driving on a deflated tyre, or irreparable damage to the tyre may be caused.
Before using the aerosol, carefully read all the instructions on the canister, or on any literature accompany-
ing the product. The following instructions apply to the use of Holts Tyreweld:
1. Remove the object causing the puncture, and position the wheel with the puncture site lowermost. Deflate
the tyre fully.
2. Shake the can vigorously. In cold conditions, warm the can using the car's heater outlets, or by body
warmth.
3. Screw the aerosol tube onto the tyre valve, remove the cap, hold the can upright and press the button
until the tyre is firmly inflated.