Filter
Top Products
This unit is designed for vacuuming leaves, grass
clippings, other organic materials, and quickly loading
them from the ground into a truck.
Vacuuming sand, rocks, and hard litter will affect the
longevity of this machine, and can cause part damage.
The Shredding TruckLoader is designed to be used in
conjunction with a truck that has a receiver box installed.
Be sure the receiver box is strong enough to withstand a
high velocity and force of the incoming debris.
A. Mount the Shredding TruckLoader Frame
Mount the Shredding TruckLoader frame to the frame or
swing away, and secure frame with four
1
/
2
” hex head
bolts (Grade Five or better). Do not use the 4 smaller
holes for mounting. These are for shipping purposes
only.
B. Install Discharge Chute to Power Unit
1. Slide the flange clamp plate (720253.10) over the
discharge chute deflector down to the flange.
2. Orient discharge chute (4163559.10) so its flange is
facing the top of the Shredding TruckLoader housing,
and slide the flange clamp plate (720253.10)
attached to the discharge chute over the four housing
flange studs.
6.
FLANGE RETAINER PLATE
HOSE FLANGE
INLET FLANGE
KNOBS
WELD PIN
FLAPPER
RETAINER
FLAPPER
SAFETY SWITCH
Assembly Instructions
WARNING DANGER
NEVER RUN OR OPERATE YOUR MACHINE
UNLESS DISCHARGE CHUTE IS DIRECTED
INTO A RECEIVER BOX, AND THE INTAKE
HOSE IS INSTALLED.
3. Direct discharge into receiver box of the transport
vehicle, and affix it with two knobs (38524), two nylon
insert nuts (64229-03) and washers (64163-31) as
shown below.
4. Position deflector (720240.17) to desired opening and
secure adjusting knob (910131).
C. Change Discharge Chute Direction
1. Loosen knobs (38524) and nuts (64229-03).
2. Swivel discharge chute to desired direction.
3. Affix chute by retightening knobs and nuts.
4. Additional tools are not needed.
D. Attach Hose to Power Unit
1. Insert Hose flange assy (720101.17) attached to
the hose (720106) in the space (gap) between
inlet flange (720211) and flange retainer plate
(720251.10). Welded retaining pin on the inlet flange
will prevent hose from sliding out of the slot.
DISCHARGE CHUTE
(4163559.10)
KNOB (910131)
KNOBS (38524)
LOCK NUTS & WASHERS
(64229-03 & 64163-3)
(2 PLACES)
FLANGE CLAMP
PLA TE
(720253.10)
DEFLECTOR (720240.17)
MOUNTING HOLES FOR THE
1/2" HEX HEAD BOLTS
FOR SHIPPING PURPOSES
ONLY, DO NOT USE FOR
MOUNTING (4 PLACES)
BOTTOM VIEW OF TRUCKLOADER