Filter
Top Products
Manual English
2
Introduction
Thank you for purchasing the LINDY HDMI extender 100m or 250m version. These extenders
allow HDMI audio, video and HDCP signals to be transmitted over very long distances using
readily available, low cost CAT5e cable. Two models are available: a 100m version and a 250m
version. Both models can support HDMI resolutions of up to 1080p. (This manual will
demonstrate the installation and use of the 250m version)
Features
• Long distance HDMI signal transmission using CAT5e or higher cable
• Cost effective solution minimizes the use of expensive HDMI cable
• HDMI 1.2 compliant, HD Ready & 1080p capable with HDCP 1.1 support
• Supported resolutions: HDMI - 480i/480p, 576i/576p, 720P@50/60Hz, 1080i@50/60Hz,
1080p@50/60Hz
• Supports High Definition audio, Dolby Digital True HD and DTS-HD
• Adjustments for equalizer and gain
• Pure hardware solution, no software required
Installation
1. Before commencing installation, please ensure that all devices are powered off
2. Connect the HDMI source to the HDMI transmitter device using an HDMI cable
3. Connect one end of the Cat 5/5e/6 cable to the output port on the transmitter and the
other end to the input port of the receiver (38021 100m or 38022 250m)
4. Use another HDMI cable to connect your HDMI display to the HDMI out port on your
HDMI receiver
5. Once all cables are connected to the transmitters and receivers, power on all devices
6. If required, use the equalizer and gain control to adjust the picture quality
Description
1. HDMI in: from HDMI source
2. RJ45 video out to receiver
3. RJ45 DDC out to receiver
4. Power adapter input
5. Equalizer control knob
6. Gain control knob
7. RJ45 DDC in from transmitter
8. RJ45 Video in from transmitter
9. HDMI out: to remote display monitor
10.Distance control jumper