Filter
Top Products
Front and Rear Window
Defroster Controls
Press to clear the
front or rear window
of thin ice and fog.
The rear defroster also works to clear the
heated outside mirrors (if equipped). The rear
defroster turns off after a predetermined time,
or when the ignition is turned off.
Climate Control System
Please see reverse side for more details.
Auxiliary Power Point
Located under the instrument panel, the
auxiliary power point is an additional power
source for electrical accessories. Improper use
of the power outlet may cause damage not
covered by your warranty.
Six CD Sound System
Please see reverse side for more details.
Steering Wheel
Controls (if equipped)
Please see reverse side for more details.
Speed Control
To operate, the speed control
must be ON and the vehicle’s
speed must be at or above 30
mph (48 km/h). To set a
speed, press SET+. To set a
higher speed, press and
hold SET+ until the
desired speed is
reached. Vehicle
speed can also be increased incrementally 1
mph (1.6 km/h) by briefly tapping SET+. To set
a lower speed, press and hold SET– until the
desired speed is reached. To disengage the
speed control without erasing the previously
programmed set speed, depress the brake
pedal. Pressing RESUME will return to a
previously set speed. To turn the speed control
off, press the OFF button or turn off the ignition.
Traction Control
TM
This system allows your vehicle to
make better use of available traction
on slippery surfaces. The system
defaults to ON; however, should
your vehicle become stuck, try
switching the traction control off.
Turn Signal and
Wiper/Washer Control
Rotate the control to the desired interval, low or
high speed. The bars of
varying length
represent the wiper
speed for
continuous and
intermittent wipers. Rotate up for fast intervals and
down for slow. Push the end of the stalk to activate
the washer. With a quick push and hold, the
wipers will swipe three times with washer fluid.
Push and hold for a longer wash cycle.
The exterior lamps will turn on with the ignition
on, headlamp control in the autolamp position
and the windshield wipers are turned on.
Power Adjustable
Foot Pedals (if equipped)
Press and hold the rocker control to
adjust the accelerator and brake
pedal toward you or away from you.
Adjust the pedals only when the
vehicle is stopped and the gearshift
lever is in the P (Park) position.
Headlamp Control
Rotate clockwise one position to
turn on the parking, instrument
panel, license plate, and tail
lamps. Rotate to the second
position to also turn on the
headlamps. Rotate
counterclockwise to activate autolamp, which
provides light-sensitive automatic on-off control of
the exterior lights and keeps them on for a short
period of time after the ignition is turned OFF.
Daytime Running Lamps Feature
(if equipped) This feature automatically turns on
the high beam headlamps with reduced output
whenever the key is in the ON position, the
transmission is not in PARK, and is not turned on
by another feature, such as, using the headlamp
control or autolamp.
Fog Lamps (if equipped) To turn on the fog
lamps, pull out the headlamp switch. Works in
parking lamps, low beams and autolamp.
Panel Dimmer Control
Use to adjust the
brightness of the
instrument panel during
headlamp and park lamp
operation. Rotate to the right to brighten and
to the left to dim. Rotate fully to the right to
also turn on the dome lamp. To turn off the
dome lamp, rotate to the left.
ABS Warning Lamp
This lamp illuminates briefly when the
ignition is turned to the ON position.
In an emergency, apply continuous
force on the brake to prevent wheel
lock when braking on slippery surfaces -
do not pump your brakes. Any pulsation or noise
you may feel or hear is normal.
Service Engine Soon Lamp
This lamp illuminates briefly to
ensure the system is functional. If
the light comes on after the engine
is started, please refer to your
Owner’s Guide. To help prevent activation,
always secure your fuel cap by turning it
clockwise 1/4 of a turn until it stops.
If the fuel cap is not properly secured, the
warning "Check Fuel Cap" will also be
displayed on the message center. The warning
will be reset once the cap is properly tightened
and your vehicle is driven a short distance.
Electronic Message Center
Please see reverse side for more details.
Gearshift/Overdrive Control
Overdrive is the normal drive position for the
best fuel economy. Only
deactivate (OFF) overdrive
when driving with a heavy
load, towing a trailer up or
down steep hills, or when
additional engine braking is
desired. To deactivate, press the transmission
control switch (TCS) located on the end of the
gearshift lever.
Clock
To set the instrument panel mounted clock,
press the right or left control to increase or
decrease the time displayed.
1
2
3
4
6
7
Headlamp
Control
Panel
Dimmer
Control
ABS
Warning
Lamp
Electronic
Message
Center
Clock
Audiophile Six CD
Radio System
Auxiliary
Power Point
Front and
Rear Window
Defroster
Controls
Speed Control
Traction
Control
TM
Power
Adjustable
Foot Pedals
Turn Signal
and Wiper/
Washer
Control
Steering
Wheel Controls
(if equipped)
Remote Entry System
Press this control
once to unlock the
driver’s door,
and twice to
unlock all doors.
Press this control once
to lock all doors; the park lamps
will flash to confirm that all doors
are closed and locked. If you press a second
time, the horn will chirp and the park lamps
will flash.
Press this control to open the trunk. If
equipped with a power trunk, press
twice to open and twice to close.
Press this control to activate the panic
alarm. To deactivate, press the control
again, or turn the ignition to the ACC,
ON or START position.
Memory Functions (if equipped)
Each key fob corresponds to different memory
positions. Key fob 1 corresponds to memory
setting 1, while key fob 2 corresponds to
memory setting 2.
You may set the memory functions for the
driver’s seat, side view mirrors, and adjustable
pedals by using the SET memory control located
on the driver’s door. To deactivate the memory
feature of your key fob, or to learn more about
any of your memory settings, please consult
your Owner’s Guide.
Heated Seats (if equipped)
Push the right portion of the
control for maximum heat.
Push again to deactivate. Push
the left portion for minimum heat. Push again
to deactivate. The heated seats will activate
when the ignition is in the RUN position, and,
if activated, turn off automatically when the
ignition is switched off.
Keyless Entry System
With this control you can open the trunk or
lock/unlock all doors without using a key. First,
enter your five-digit program code and then (within
5 seconds) press the corresponding quick key:
Open the trunk..........................5-6
Unlock all doors........................3-4
Lock all simultaneously.....7-8 and 9-0
If your vehicle is equipped with a power trunk,
pressing the 5-6 control (within 5 seconds of
entering your access code) will close the trunk.
Power Lumbar Support (if
equipped)
This control is located on the front
of the seat cushion on the inboard
side of the seat. Press the top side
of the control to adjust firmness.
Press the bottom side of the control
to adjust softness.
A d d i t i o n a l F e a t u r e s
Service
Engine Soon
Lamp
1
3
4
5
7
11
9
8
12
13
14
Gearshift/
Overdrive Control
6
15
16
8
9
Climate
Control
System
10
5
2
Congratulations on acquiring a Lincoln Town Car. Your
elegant new vehicle possesses many sophisticated features,
from steering wheel mounted controls to power adjustable
foot pedals. This Quick Reference Guide was designed to
acquaint you with many of the features you’ll be using most.
For detailed information, please consult your Owner’s Guide.
10
12
13
11
14
15
16