Filter
Top Products
1
© Copyright 2005
Manual No. 701-094M
Before You Start
These optional assembly instructions contain only
information required to assemble the Engine Cold
Weather Kit to the NT Series Treker. A detailed
Operator’s Manual was supplied with the Treker. Refer
to the Operator’s Manual for additional specific
information especially information relating to safety
concerns. Also included in the Operator’s Manual is
important information on operation, adjustment,
troubleshooting, and maintenance for this attachment
(some manual sections do not apply to all options).
A separate Parts Manual for replacement parts can be
purchased from your dealer or available free of charge at
www.landpride.com. Have model and serial numbers
handy when placing an order.
Manual Part Numbers:
• Operator’s Manual . . . . . . . . . . . . . . . . . 700-108M
• Parts Manual . . . . . . . . . . . . . . . . . . . . . 700-108P
General Information
This Engine Cold Weather Kit w/Diverter applies to:
Treker 4200/4400 NT Series............... Kit No. 701-092A
The Engine Cold Weather kit is designed to prevent or
eliminate effects of carburetor icing on the 20hp Honda
engine for Land Pride Trekers. Carburetor icing may occur
at temperatures of 45 degrees Fahrenheit and lower.
Typical symptoms will be loss of power, hard starting,
engine backfiring, plug fouling, gas in the oil, or engine
stalling. Application of this kit will force warm air directly
into the air intake filter reducing or eliminating the icing
condition and its related symptoms. Vehicles started at
freezing temperatures should be allowed to warm-up for
approximately 4-5 minutes prior to full vehicle operation.
When outdoor temperatures are consistently above 45
degrees Fahrenheit, the air bypass valve should beturned
to the summer setting to bypass air away from the engine
exhaust manifold or a noticeable power loss will occur.
The oil and filter must be changed if plugs have become
fouled and if the dipstick indicates an oil overfill condition
with gas in the oil. Do not overfill engine with oil or plug
fouling will likely reoccur.
Tools required:
• 3/8" Nut driver & drill
• 1/2” Wrench or socket and driver
When you see this symbol, the subsequent
instructions and warnings are serious - follow
without exception. Your life and the lives of
others depend on it!
!
• 9/16" Wrench or socket and driver
• 13 mm Socket
• Straight blade screwdriver
• Cross blade screwdriver
• Knife
Assembly Instructions
A detailed listing of parts for Kit No. 701-092A is
provided on page 3. Use the list as a checklist to
inventory parts received.
Initial Preparations
!
CAUTION!
Securely support cargo box in the up position to prevent
injury when working under the cargo box.
1. Park vehicleon a flat surface,move gearshift lever to
neutral, set park brake, and chock front and back of
the right rear wheel to prevent the vehicle from
rolling.
2. Raise cargo box fully up and securely support it in
the up position to prevent injury while working
around the engine.
3. Turn off engine and remove ignition key.
Refer to Figure 1:
4. Loosen the two worm drive hose clampssecuring the
rubber air intake hose and save for reuse.
5. Remove rubber air intake hose and save for
modification and reinstallation.
Existing Air Intake Assembly
Figure 1
NOTE: It is not necessary to disconnect engine
snorkel and snorkel hose.
AirCleaner
Canister
SS Hose
Clamp
Rubber Air
Intake Hose
21127
Treker 4200/4400 NT Series Manual No. 701-094M
Engine Cold Weather Kit W/Diverter
Assembly Instructions
11/23/05