Filter
Top Products
La Crosse Technology, Ltd Page 4
No WWVB Tower Icon
The atomic alarm clock has not received a WWVB time signal in the past 24 hours.
Position the atomic alarm clock for better reception.
Hold the WAVE button to send the Atomic alarm clock on a WWVB signal search at night.
Allow up to 5 nights to receive the time signal.
Set Time Alarm
Press and release the ALARM button once to show Alarm Time. The letters AL will appear
where the seconds display.
ALARM HOUR: Hold the ALARM button to enter alarm time setting mode. The Alarm Hour
will flash. Use the UP or DOWN buttons to set the Hour. Press and release the ALARM
button.
ALARM MINUTE: The Alarm Minutes will flash. Use the UP or DOWN buttons to set the
Minutes. Press and release the ALARM button to exit.
Activate/Deactivate Time Alarm
ACTIVATE:
Press and release the ALARM button to activate the alarm. The alarm icon (((●))) appears
when alarm is active.
DEACTIVATE:
Press and release the ALARM button to deactivate the alarm. The alarm icon will disappear
when alarm is inactive.
Note: When the alarm sounds, it will continue for two minutes then shut off.
Snooze Alarm
When the alarm sounds, press the SNOOZE/LIGHT button to trigger snooze alarm for 10
minutes.
The snooze icon Zz will flash when the snooze feature is active.
To stop alarm for one day, press ALARM button, while in snooze mode.
The alarm icon (bell) will remain solid.
Atomic Alarm Clock has distorted or frozen display
Explanation: On a brand new alarm clock, check for thin plastic film of printed scratch guard
that may be on the screen of the alarm clock. This thin piece of plastic has printed numbers for
store displays. When the batteries are installed, the “real” numbers show behind the printed
scratch guard and create distortion.
With all power removed, the alarm clock should be blank.
If numbers still appear, please check for scratch guard.
Power:
Check that the batteries are installed correctly.
This is generally a power related issue.
Batteries may be overpowered or underpowered.
Remove batteries from alarm clock.
Press any button 20 times. Leave the batteries out of the display for 2 hours.
Insert and batteries into the alarm clock.