Filter
Top Products
Replacing the headlight lamp *
Remove the screws [1] on the left and right and tilt the headlight mask down towards the
front.
NEVER TOUCH THE GLASS OF THE BULB WITH YOUR FINGERS. THE GLASS OF THE BULB MUST
REMAIN ABSOLUTELY FREE FROM GREASE. HEAT WILL OTHERWISE CAUSE THE GREASE TO EVAP-
ORATE AND SETTLE DOWN ON THE REFLECTOR.
BULB FOR HIGH BEAM [A]:
Remove the rubber cap [2] and pull off the connector [3]. Detach the retaining clip and
remove the bulb.
Insert a new bulb, attach the retaining clip, connect the connector and mount the rubber
cap.
BULB FOR LOW BEAM [B]:
Remove the rubber cap [4] and pull off the connector [5]. Detach the retaining clip and
remove the bulb.
When you insert the new bulb, make sure the tab fits in the corresponding recess in the
socket.
Attach the retaining clip, connect the connector to the bulb and mount the rubber cap.
BULB FOR THE PARKING LIGHT:
Since a number of parts need to be removed to replace the parking light bulb, we recom-
mend that you have the lamp replaced at an authorized KTM workshop.
MAINTENANCE WORK ON CHASSIS AND ENGINE »
57
1
1
B
A
3
4
2
5