KTM 200 Motorcycle User Manual


 
ENGLISH
6
Electronic speedometer, indicator lamp (EXC)
The green control lamp 1 flashes in the same rhythm as the
flashing indicator when the indicator is working.
The blue control lamp
2 lights up when the high beam is on.
Electronic speedometer
The electronic speedometer display is activated as soon as the engine is
switched on and the motorcycle starts to move.
The engine must be started in order for the speedometer to be supplied
with electricity from the generator. An impulse must be received from the
wheel sensor to activate the display; the front wheel must turn at least one
time.
TEST
All of the display elements will light up for 1 second for the function test.
WS (wheel size)
The display will change and briefly show the diameter of the front wheel in
millimeters.
If the front wheel does not turn, the display will automatically change to the
SPEED/H mode.
If the front wheel turns, the display will automatically change to the
SPEED /ODO mode.
SPEED/H (hours) display mode
When you stop driving and no impulses are sent from the wheel sensor, the
display mode will automatically change from SPEED/ODO to SPEED/H. H
shows the operating hours. The operating hour counter starts to count as
soon as you start the engine. The displayed figure cannot be cleared.
Service intervals are indicated in operating hours for some KTM offroad
motorcycles, making the operating hour counter a very practical function.
Anzeigemodus SPEED/ODO
The SPEED/ODO mode shows the speed and the total kilometers traveled.
When the front wheel stops turning, the display will automatically change
to the SPEED/H mode.
The information will disappear in the display when the front wheel stops
turning for 1 minute.
NOTE:
A Tripmaster switch is available as an accessory and enhances the electronic
speedometer by providing the following functions:
2x Tripmaster
2x chronometer for the lap time
Average speed
Maximum speed
Clock
Display in miles
1
2