Storage
If the engine will be out of service for two months or
more, use the following storage procedure:
1 .
2 .
Clean the exterior surfaces of the engine.
Change the oil and filter while the engine is still
warm from operation. See “Change Oil” on
page 8.
3
. Change oil in reduction gear unit, if so equipped.
Refill with the same oil as used in engine
crankcase for season of operation. See page 8.
4 . The fuel system must be completely emptied, or
the gasoline must be treated with a stabilizer to
prevent deterioration. If you choose to use a
stabilizer, follow the manufacturers
recommendations, and add the correct amount
for the capacity of the fuel system. Fill the fuel
tank with clean, fresh gasoline. Run the engine
for 2-3 minutes to get stabilized fuel into the
carburetor.
To empty the system, run the engine until the fuel
tank and system are empty.
5
.
Remove the spark plug. Add one tablespoon of
engine oil into the spark plug hole. Install the
plug, but do not connect the plug lead. Crank the
engine two or three revolutions.
6 Remove the spark plug. Cover the spark plug
hole with your thumb, and turn the engine over
until the piston is at the top of its stroke.
(Pressure against thumb is greatest.) Reinstall
the plug, but do not connect the plug lead.
7
Store the engine in a clean, dry place.
Parts Ordering
The engine Specification, Model, and Serial Numbers
are required when ordering replacement parts from
your Kohler Engine Service Dealer. These numbers
are found on the identification plate which is affixed to
the engine shrouding. Include letter suffixes if there
are any. See “Engine Identification Numbers” on
page 5.
Always insist on genuine Kohler parts. All genuine
Kohler parts meet strict standards for fit, reliability,
and performance.
Major Repair
Major repair information is available in Kohler Engine
Service Manuals. However, major repair generally
requires the attention of a trained mechanic and the
use of special tools and equipment. Your Kohler
Engine Service Dealer has the facilities, training, and
genuine Kohler replacement parts necessary to
perform this service. For Sales & Service assistance
call I-800-544-2444 (U.S. & Canada) or contact your
Kohler Engine Dealer or Service Distributor, they’re in
the Yellow Pages under Engines-Gasoline.
Model Designation
The model number designates the cubic inch
displacement and the number of cylinders - Model
K241A, for example designates 24 cubic inch
displacement, 1 designates single cylinder. The letter
suffix designates a specific version as follows:
Suffix
A
EP
P
Q
R
S
T
Designates
Oil Pan Type
Generator Set
Pump Model
Quiet Model
Gear Reduction
Electric Start
Retractable Start
14