Kohler CV740 Automobile Parts User Manual


 
8
If the battery charge is not sufficient to crank the
engine, recharge the battery (see page 14).
Operating
Angle of Operation
This engine will operate continuously at angles up to
25°. Check oil level to assure crankcase oil level is at
the “FULL” mark on the dipstick.
Refer to the operating instructions of the equipment
this engine powers. Because of equipment design or
application, there may be more stringent restrictions
regarding the angle of operation.
NOTE: Do not operate this engine continuously at
angles exceeding 25° in any direction. Engine
damage could result from insufficient
lubrication.
Maintenance Instructions
Maintenance, repair, or replacement of the emission control devices and systems, which are being done at the
customers expense, may be performed by any non-road engine repair establishment or individual. Warranty
repairs must be performed by an authorized Kohler service outlet.
WARNING: Accidental Starts!
Disabling engine. Accidental starting can cause severe injury or death. Before working on the engine or equipment, disable
the engine as follows: 1) Disconnect the spark plug lead(s). 2) Disconnect negative (-) battery cable from battery.
Maintenance Schedule
These required maintenance procedures should be performed at the frequency stated in the table. They should
also be included as part of any seasonal tune-up.
Cooling
NOTE: If debris builds up on the grass screen or
other cooling areas, stop the engine
immediately and clean. Operating the engine
with blocked or dirty air intake and cooling
areas can cause extensive damage due to
overheating. See Clean Air Intake/Cooling
Area, page 13.
WARNING: Hot Parts!
Engine components can get extremely hot from operation. To
prevent severe burns, do not touch these areas while the engine
is running, or immediately after it is turned off. Never operate
the engine with heat shields or guards removed.
Engine Speed
NOTE: Do not tamper with the governor setting to
increase the maximum engine speed.
Overspeed is hazardous and will void the
engine warranty. The maximum allowable
high idle speed for these engines is 3750 RPM,
no load.
1
Perform these maintenance procedures more frequently under extremely dusty, dirty conditions.
2
Only required for Denso starters. Not necessary on Delco starters. Have a Kohler Engine Service Dealer perform these services.
3
Cleanout kits 25 755 20-S (black) or 25 755 21-S (gold) allow cooling areas to be cleaned without removing shrouds.
Frequency Maintenance Required
Fill fuel tank.
Check oil level.
Check air cleaner for dirty
1
, loose, or damaged parts.
Check air intake and cooling areas, clean as necessary
1
.
Service precleaner element
1
.
Change oil filter.
Check spark plug condition and gap.
Replace fuel filter (Carbureted engines).
Annually or
Every 500 Hours
Have bendix starter drive serviced
2
.
Have solenoid shift starter disassembled and cleaned
2
.
Daily Or Before
Starting Engine
Every 25 Hours
Every 100 Hours
Every 200 Hours
Every 1500 Hours
Replace fuel filter
1
(EFI engines).
Replace air cleaner element
1
.
Change oil (more frequently under severe conditions).
Remove cooling shrouds and clean cooling areas
1,3
.
Check oil cooler fins, clean as necessary (if equipped).
Every 250 Hours
Replace heavy-duty air cleaner element and check inner element
1
.