Kenwood KVS-50 Automobile Electronics User Manual


 
Important
Please wait until you’ve connected
all of the cables before plugging the
receiver or amplifier into the AC
wall outlet and turning it on.
KVS-50 Center Speaker
We designed the KVS-50 Center
Speaker with both a flat side with an
adjustable leg, and an angled side.
You can place the speaker on either
side (following the instructions
below).
Place the speaker directly above
or below the middle of the TV
screen (the speaker is magneti-
cally shielded, so you don’t have
to worry about picture discol-
oration).
Place the speaker as close as
possible (within 2 feet) to the
same height as the left and right
front speakers.
If you place the speaker on the
floor, place it on its angled side,
aiming it up toward the listeners
at seated ear level. In this case,
you’ll probably want to reverse
the speaker grille so that the
lettering is right side up.
If you place the speaker on top
of the TV, place it on its flat side,
and use the adjustable leg on the
back to aim it down toward the
listeners at seated ear level.
KVS-60 Surround Speakers
Mount the speakers on the wall
using picture hangers (40 lb test),
or place them on shelves.
(Attach the speaker wire first;
see the instruction below).
Place the speakers directly to the
sides of the listening position,
with the large grille covers point-
ing at the listeners.
If the listening area has more
than 1 row of seats, place the
speakers in the middle of the
listening area.
Place the speakers at least 2 feet
above the listener’s heads, with
the back of the cabinet flush
against the wall.
Place both speakers so that the
directional arrows on the back of
the cabinet point toward the TV.
You’ll need to place one speaker
upside-down to do this. (There is
mounting hardware on both
ends of the speaker). This will
not affect its sound. You may
want to reverse its grille so that
the lettering is right side up.
Placing the speakers
3.