Kenwood DNX7210BT GPS Receiver User Manual


  Open as PDF
of 58
 
9898 99
Return to the Top page
Troubleshooting
Return to the Top page
Troubleshooting
Error Message Cause Solution
USBDevice
Error!!
TheconnectedUSBdeviceisrated
acurrentcapacityhigherthanthe
allowablelimit.
ChecktheUSBdevice.Sometroublemayhave
occurredtotheconnectedUSBdevice.
Changethesourcetoanysourceotherthan
USB.RemovetheUSBdevice.
Authorization
Error
ConnectiontotheiPodhasfailed.
•RemovetheiPodandthenreconnectit.
•TheunitdoesnotsupporttheiPod.
SeeConnectable iPod/iPhone (P.102).
Updateyour
iPod
TheiPod’ssoftwareisanolder
versionwhichtheunitcannot
support.
TheunitmaynotsupporttheconnectediPod
model.
ConfirmthatthesoftwarefortheiPodisthe
latestversion.
SeeConnectable iPod/iPhone (P.102).
Navigation
Error.Please
turnonpower
againlater.
Thecommunicationerrorhas
occurredduetoseverelycold
temperature.
Turnonpoweragainafterwarmingyourcar
interior.
Resetting The Unit
Iftheunitortheconnectedunitfailstooperateproperly,resettheunit.
1
Press the <Reset> button.
The unit returns to factory settings.
NOTE
•DisconnecttheUSBdevicebeforepressingthe<Reset>button.Pressingthe<Reset>buttonwiththeUSBdevice
connectedcandamagethedatastoredintheUSBdevice.ForhowtodisconnecttheUSBdevice,seeHow To
Play Media (P.13).
•Whentheunitisturnedonafterresetting,theInitialSETUPscreenappears.SeeInitial setup (P.11).
 previous next