Filter
Top Products
72 DNX series DNX7360BT/ DNX7360BTM
Setup Menu
EXT SW Setup EXT SW Setup
Sets up the exteral switch power mode.
1 Display the EXT SW screen
Touch [
] > > [ ] > > [System] > >
[EXT SW]. (page 67)
2 Perform EXT SW Setup
[SW1 Name]/ [SW2 Name] Sets the
name of the external device. See <How
To Use the Character Entry Screen>
(page 72) for information on how to enter
a name.
[Output Pattern] Sets the power signal
output mode.
(
EXT SW1: Pulse, EXT SW2: Level)
"Pulse": Generates a single power signal
pulse.
"Level": Continues output of high
power signal.
Sets to turn output on/off each time the
button on the EXT SW Control screen is
touched. See <External Device Power
Supply Control> (page 47).
[Pulse Set] Sets the Pulse signal output
time.
Outputs 500ms when "1" is set.
Increases by 200ms with each step. Up
to 100 steps can be set.
How To Use the Character Entry Screen
1
1
1
1 Enters characters.
[2], [3] Shifts the cursor.
[5], [∞] Scrolls up or down the
character button display.
[Shift] Toggles between uppercase and
lowercase.
[qwe]/ [abc] Sets the key layout of the
character buttons.
abc : Alphabetical key layout.
qwe : Qwerty key layout.
[Clear] Clears the character.
If you erase a character, locate the
cursor on it and touch this button.
[Space] Enters a space.
⁄
• You can enter characters only after you have
applied the parking brake.