Filter
Top Products
English 81
Connecting Wires to Terminals
Connect to vehicle's reverse lamp
harness when using the optional rear
view camera.
(Parking sensor wire)
Connect to the vehicle's parking
brake detection switch harness.
For best safety, be sure to connect
the parking sensor.
⁄
Light Green
Extension cable (Accessory 2)
Antenna Cord
FM/AM antenna input
Accessory 1
FUSE ( 10A )
(Steering remote control wire)
Light blue/Yellow
To use the steering wheel remote control feature,
you need an exclusive remote adapter (not supplied)
matching your car is required.
If no connections are made, do not let the cable come out from the tab.
(Mute control wire)
Brown
To the terminal that is grounded when either the
telephone rings or during conversation. (To connect the
Kenwood navigation system, consult your navigation
manual.)
To car light control switch
(Dimmer control wire)
Orange/White
Depending on what antenna you are using, connect
either to the control terminal of the motor antenna, or to
the power terminal for the booster amplifier of the film-
type antenna. (Max. 300 mA, 12 V)
(Antenna control wire)
Blue
When using the optional power amplifier, connect to its
power control terminal.
(Power control wire)
Blue/White
Yellow (Battery wire)
Red (Ignition wire)
White ª / White/black · : To front speaker (left)
Gray ª / Gray/black · : To front speaker (right)
Green ª / Green/black · : To rear speaker (left)
Purple ª / Purple/black · : To rear speaker (right)
(Reverse sensor wire)
Purple/White
Bluetooth Microphone (Accessory
9) DDX790/DDX770/DDX7070BT/
DDX470/DDX4070BT only
Ignition key switch
ACC
Car fuse box
(Main fuse)
Subwoofer Preout (monaural)
Black (Ground wire) · (To car chassis)
Battery
EN_GET0907-001A_KR.indb 81EN_GET0907-001A_KR.indb 81 12/11/13 10:1412/11/13 10:14