Kawasaki T4872 Offroad Vehicle User Manual


 
8
P9723b-0920
Children can be harmed by small parts,
sharp edges and sharp points in the vehicle's
unassembled state, or by electrical items.
Care should be taken in unpacking and
assembly of the vehicle. Children should
not handle parts, including the battery,
or help in assembly of the vehicle.
• Plug the charger connector into the battery
A
.
• Plug the charger into a standard wall outlet
B
.
Notes:
- Use the charger only in a wall outlet. Do not plug the AC
adaptor into a ceiling outlet.
- If power flow to the wall outlet is controlled by a switch,
make sure the switch is “ON”.
• Before first-time use, charge the battery for at least 18 hours.
Never charge the battery longer than 30 hours.
• Recharge the battery for at least 14 hours after each use of
your vehicle. Do not charge the battery longer than 30 hours.
• Once the battery is charged, disconnect the charger connector
from the battery. Unplug the charger from the wall outlet. The
battery is now ready to be installed in your vehicle. Please
see the Battery Installation section on page 15 for detailed
instructions on installing your battery. If your battery is already
installed in your vehicle, simply re-connect the motor harness
connector to the battery.
Battery
Charger
Connector
1
ASSEMBLY
A
B
WARNING
• Slide a wheel cover, indented side down, onto the rear axle.
• Locate a rear wheel. Slide the wheel, indented side down,
onto the rear axle.
• Slide a rear wheel driver, slotted side down, onto the rear axle.
Fit the slots on the rear wheel driver onto the pegs on
the wheel.
Rear Wheel Driver
(Slotted Side Down)
Wheel Cover
(Indented Side Down)
Rear Wheel
(Indented Side Down)